Diy Satellite Installation

out every home in the country has a Satellite dishforeseeable future.
these days. If you are yet to jump on thePut the dish in place on the mast. Do not,
bandwagon, here is a basic guide to installing ahowever, tighten the bolts just yet as you need
satellite dish on your balcony.to run the Coaxial cable (this may have been
So you have been and bought your satellite dishsupplied with your dish, if not then you will need
and have it on the floor of your living room. Whatto purchase this) though the dish to the eye and
now? Well firstly, you will need to make sure youattach it with the supplied screws. Try not to
have a decent set of tools. There is nothingover-tighten as you may strip the screws.
worse than getting halfway through a job andIf you have a satellite signal meter, you can
having to give up because you didn’t haveconnect it to the other end of the cable and
all the equipment.make sure that you are getting enough strength
The first thing you are going to establish is whichfrom the signal. If not then adjust the dish slightly
direction you need to point the satellite dish, therefrom left to right until you achieve the strongest
are 2 ways you can do this. The first is to get inpossible signal.
touch with an expert at your local satellite shopOnce you have achieved the best signal you can,
and ask them. They will likely give you a compasstighten the bolts connecting the dish to the mast.
direction, so you will also need a compass. TheKeep an eye on the meter as you tighten these
second and easiest way is to simply look out yourbolts so that you don’t move the dish
window to see which way Mr Jones’ dish isslightly and ruin the signal.
pointing. Generally though, you need it to beNow, again, looking at your signal meter, slowly
pointing at the southern sky.move the reflector up and down until you achieve
Once you have determined the direction thethe strongest signal possible. Once you have
Satellite needs to be pointing, you can go aheadfound this position, tighten the reflector while
and bolt the mast down. This is probably thechecking the meter, again, to make sure that you
most important part of the whole job. If thedon’t throw the signal by tightening the
mast is not solid then a couple of weeks downscrews.
the line, you could be taking a trip to the satelliteThis is the dish set up. You can run the cable
shop to replace your broken dish. If youfrom the dish to your receiver box. If you have
don’t bolt it down facing the right wayto go through a wall, use the biggest, most
then you will be watching static for thepowerful drill you can.