| If you have poor picture quality one of the | | | | came with the meter, you should at this stage |
| quickest things you can do is to just take a quick | | | | already have the batteries in your meter and |
| look from the ground outside to see if your dish | | | | powered on and adjust the meter to get the |
| or aerial looks as though it may have moved out | | | | strongest signal you can get. |
| of its original alignment, also from the ground take | | | | If you get a very strong signal but still get a poor |
| a look to see if you can see any obvious wires | | | | picture you may need to have your TV checked |
| that may have broken or come loose. If you can | | | | if the cable came directly from the back of the |
| see something wrong and it is above head height, | | | | TV. But if you cannot get a strong signal at the |
| we would advice you to call a engineer as falling | | | | meter then take your meter and go to the |
| just a couple of feet off a ladder can cause | | | | connection nearest to where the cables enter the |
| serious or fatal injury. | | | | property, probably a wall socket. When you |
| If everything looks OK outside move back inside | | | | purchased your meter you should of also got a |
| the property to the TV closest to where the | | | | short cable with a male aerial plug on both sides, |
| cables enter the property and also as poor picture | | | | you will need this now. |
| quality, at this point you will also need a satellite | | | | Connect one side to your meter and one side to |
| finder or a aerial signal strength meter, we will call | | | | the aerial or dish wall socket and test for a signal |
| this from here on in your meter, you will also | | | | as above and as described in the meter |
| need a ohmmeter or other device for measuring | | | | instructions, if you still get no signal here then the |
| resistance. All three are quite cheap and can be | | | | problem is probably outside and I would advice |
| purchased online or from a shop that supply | | | | you to call a engineer capable of working at |
| aerials or satellite equipment, after you have read | | | | height, but if you do get a strong signal here all |
| and implemented all the instructions that come | | | | you need do is keep on checking individual pieces |
| with your meter, disconnect the aerial from the | | | | of wire with your meter and ohmmeter until you |
| back of the TV and connect the cable to your | | | | find where the signal stops and change or repair |
| meter in accordance with the instructions that | | | | as needed. |